top
Shanghai Clirik Machinery Co.,Ltd is a professional manufacturer of grinding machines, crushers and other equipment. The gypsum grinding mills are: European version of coarse powder mill, Raymond mill, high pressure suspension roller mill, three Ring/four-ring superfine mill. It is an ideal equipment for processing limestone, calcite, calcium carbonate, barite, etc. The fineness of processing can be adjusted freely between 5- and 3000 mesh. At the same time, the mill production line can be customized for customers and equipped with suitable equipment. Until you are satisfied. If you need, you can consult the 24-hour service hotline: 008613512155195
gypsum grinding mill plant

Gypsum grinding mill is mainly used in mining, building materials, chemical, metallurgical and other industries. It can be used for kaolin, limestone, talc, barite, dolomite, calcite, marble, gypsum, bentonite, mica, graphite and other moisture content less than 5 %, Mohs hardness of less than 6 grades of a variety of materials for ultra-fine powder processing, the finished product size up to 3000 mesh.
 

How to do the maintenance of the gypsum mill?

 
1. The gypsum mill main engine refueling time is once per shift, but it must be noted that when the oil in the oil cup is not lost or the loss is too slow, the oil passage should be cleaned immediately.
 
2. It is forbidden to enter the metal block into the gypsum mill, otherwise it will damage the grinding roller and the grinding ring, even the center hanger.
 
3, the feed should be even, can not be ignored. Too much feed will block the air duct, reduce the output, burn the motor easily, and feed too little will also feed the output. Feeding particle size: The hard material should be less than 15 mm in diameter, and the soft material can be 20 mm in diameter. It is strictly forbidden to add large materials into the machine.
 
4. Air volume adjustment: The air volume control valve located on the air intake pipe of the fan is generally opened to the maximum position and adjusted according to the fineness and output requirements. The regulating valve located on the exhaust pipe of the exhaust gas outlet can be adjusted to the inlet without dust emission. The air volume is small and the fineness is high. However, it should be noted that the air volume is too small, and the material in the air duct below the main unit is easy to precipitate. Please adjust it appropriately.
 
5, fineness adjustment: according to the size of the material, soft and hard, water content, specific gravity, the processing thickness is also different, can adjust the upper analyzer, high speed, high fineness; low speed, low fineness.
 
6. The scrapping limit of the grinding roller of the grinding machine, the remaining minimum wall thickness shall not be less than 10mm.
 
7. When stopping, first stop feeding, the main machine continues to smash, and the residual abrasive continues to be milled. After about one minute, the main motor and analyzer motor can be turned off, the grinding operation is stopped, and then the fan motor is stopped. In order to blow off the residual powder.