top
Gypsum has a wide range of uses, and the demand for gypsum mills has also increased. The following is an introduction to gypsum and a gypsum grinding plant from India. I hope that it will be helpful to friends who are looking for gypsum mill.

The main component of gypsum is hydrated calcium sulfate, with a specific gravity of 2.8-3.0g / cm³ and low hardness. Gypsum can be used in cement retarders, gypsum building products, model making, medical food additives, sulfuric acid production, paper fillers, paint fillers, etc. The application of gypsum often starts with the production of gypsum powder.
 
The production of gypsum powder requires a complete set of pulverizer equipment. The high-pressure pulverizer produced by Shanghai Clirik Machinery Co., Ltd is a fine powder mill suitable for gypsum powder grinding. It is also a classic grinding equipment. High pass rate, stable performance, and many users.
 
Gypsum grinding plant from India
Gypsum grinding plant from India

A set of 5R gypsum grinding mill that Shanghai Clirik Machinery Co., Ltd had exported to India last year is used in the processing of gypsum powder. The fineness is ground to 200 mesh, and the output reaches 8 tons. The advantages of the high-pressure mill when grinding gypsum powder are as follows:
 
Compared with other mills, the high-pressure micro-powder mill has a 800-1200 kg increase in the rolling force of the rollers on the material under the action of a strong compression spring, which saves energy, has a small investment, high efficiency, and has fewer production links. It can achieve ultra-fine powder with an average material diameter of <6.5um at one time. The grinding device adopts an overlapping multi-stage seal with good sealing performance.
 
The high-pressure mill uses wind energy to make powder at one time, eliminating the traditional screening method. In the high-pressure micro-powder grinding mill, there are mainly high-pressure springs with a pressure of 1000-1500 kg on the grinding roller hanger. After the high-pressure mill starts to work, the grinding roller rotates around the main shaft, and under the action of the high-pressure spring and eccentricity, it rolls close to the grinding ring. The pressure is 1.2 times higher than the Raymond mill under the same dynamic conditions, so the output is large For improvement.
 
In addition to the 5R model, YGM7815 / YGM8314 / YGM9517 / YGM4121 series are commonly used models of high-pressure mills. In addition, Shanghai Clirik Machinery Co., Ltd has launched a larger-capacity MTM series mill, which is also to meet Need for mass production in the powder market. WhatsApp: +86-13917147829